Chrysler neon 1997 Service Manual page 326

PL
VEHICLE SPEED CONTROL SYSTEM
REMOVAL AND INSTALLATION
SPEED CONTROL SERVO
REMOVAL AND INSTALLATION
SPEED CONTROL SERVO
REMOVAL
(1) Disconnect battery.
(2) Remove battery Thermoguard.
(3) Remove battery hold down and battery.
(4) Remove power distribution center from back of
battery tray.
(5) Disconnect speed control cable from throttle
body.
(6) Remove screw holding support strut to the
front of battery tray.
(7) Remove top two battery tray fasteners. Loosen
bottom two battery tray fasteners.
(8) Slide battery tray up, disconnect speed control
servo wiring and vacuum harness from servo (Fig. 1).
(9) Remove attaching nuts and remove speed con-
trol assembly from bottom of battery tray.
INSTALLATION
(1) For installation reverse above procedures. The
servo wiring connector should point towards the left
front corner of the vehicle with battery tray installed.
Tighten nuts to 7 N·m (60 in. lbs.) torque.
CONTENTS
page
. . . . . . . . . . . . . . . . 1
VEHICLE SPEED CONTROL SYSTEM
Fig. 1 Battery Tray and Speed Control Servo
8H - 1