Configure Ldap Server; Setup The Ipbs/Ipbl As An Ldap Server; Check Ldap Server Status - Avaya IPBS1 Installation And Operation Manual

The joint user database contains information about the users registered in the system. It also
contains the system configuration, that is the configurations made under the DECT menu.
This section describes how to do the following configurations and settings.

Configure LDAP Server

l

Check LDAP Server Status

l
Configure LDAP Replicator
l
Check LDAP Replicator Status
l
Configure LDAP Server
The IP-DECT system needs an LDAP server. If the PBX is set up as an LDAP server, the
Master should be set up as an LDAP Replicator. If the Master is set up as an LDAP Server, the
Standby Master could be set up as an LDAP Replicator, see
page 97.

Setup the IPBS/IPBL as an LDAP server

Note: The selected user name and password must be the same in both the Master and the Standby
Master. If a Multi Master system is used, the Masters must also have the same user name and password.
1. Select LDAP > Server.
2. Add a user, for example ldap-user, in the User text field.
3. Enter a password in the Password text field.
4. Select the Write Access check box.
5. Click "OK".
Check LDAP Server Status
Select LDAP > Server Status
The following information is displayed:
connections - Total number of active connections to the LDAP server
l
96
Avaya 374x DECT Telephones - User Guide
Configure LDAP Replicator on
02/2016