Table of Contents
Advertisement
Automatic
l
Note: Automatic activation cannot be configured if Provisioning is used. About
Provisioning, see
Enable the Radio
If the IPBS/IPBL shall not be used as a radio, for example only be used as a Master, it can be
disabled by marking the Disable check box.
Tip: To assign a Master, see
Select DECT > Radio.
l
Clear the Disable check box.
l
Enter IP Address to the Master and the Standby Master
All IPBS/IPBL need to know the IP address of the Master and the Standby Master.
1. Select DECT > Radio.
2. Enter the name for the Master in the Name text field.
3. Enter the password for the Master in the Password text field.
4. Enter the address to the Master in the Master IP Address text field. If this is the Master,
enter 127.0.0.1.
Note: The Master can be configured as Active or Mirror.
5. Enter the address to the Standby Master in the Alt. Master IP Address text field. If this is
the Standby Master, enter 127.0.0.1.
Note: The Standby Master can be configured as Standby or Mirror.
6. Click "OK".
7. Reset in order to make the changes take effect, see
Avaya 374x DECT Telephones - User Guide
Provisioning
1
Select the "Primary trunks prioritized" check box.
2
Set the "Supervision Timeout" to desired time. The primary trunks are automatically
changing from "Up" mode to "Active" mode when the timer is elapsed.
Example:
If the timeout is set to 600 seconds, it means that the system waits 600 seconds (10
minutes) until it is automatically up and running again (on active primary trunks). This
is the amount of time to fix any problems.
During the Supervision Timeout, there is a continuous condition check of the trunk
connection. The timer states the time it must take until a successful connection is
established in the system.
PARI
on page 89.
on page 108.
Reset
on page 141.
Operation
107
02/2016
Hide quick links:
Advertisement
Table of Contents
