Esd Handling; Safety Aspects; Ip-Dect Base Station; Regulatory Compliance Statements (Eu/Efta Only) - Avaya IPBS1 Installation And Operation Manual

ESD Handling

In the interest of quality and reliability, it is advisable to observe the following rules when
handling system parts:
Keep parts in their protective packaging until they are needed.
l
When returning system parts like EEPROMS to the factory, use the protective packaging
l
as described.
Never underestimate the damaging power ESD can have and be especially careful when
l
temperatures are below freezing point and during very warm weather in combination with
low humidity. Make sure that the environmental conditions remain within the limits
specified in the components' data sheets.
IMPORTANT: In the interest of quality and reliability system boards and other parts returned for

Safety Aspects

IP-DECT Base Station

The IP-DECT Base Station meets the valid editions of safety standard EN/IEC/CSA/UL/AU/NZS
60950-1. The system is a class III equipment for stationary wall mounting.
DECT Base Station BS3x0 and TDM-DECT Base Station DB1
The DECT Base Station BS3x0 and TDM-DECT Base Station DB1 meets the valid editions of
safety standard EN/IEC/CSA/UL/AU/NZS 60950-1. The system is a class III equipment for
stationary wall mounting.
IP-DECT Gateway (IPBL)
The IPBL meets the valid editions of safety standard EN/IEC/CSA/UL/AU/NZS 60950-1.

Regulatory Compliance Statements (EU/EFTA only)

The equipment are intended to be used in the whole EU&EFTA.
The equipment are in compliance with the essential requirements and other relevant provisions
of R&TTE Directive 1999/5/EC. The Declarations of Conformity may be consulted at:
http://support.avaya.com/DoC
28
Avaya 374x DECT Telephones - User Guide
exchange or credit may be refused if the proper protective packaging is omitted!
02/2016