Table of Contents
Advertisement
Note: When downgrading, minimum version of the software that runs on IPBS2 is 7.2.11 and on DB1
it is R3E.
Update
This section describes how to do the following configurations and settings.
Update Configuration
l
Update Firmware
l
Update the Boot File
l
Update the RFPs
l
Update Configuration
A previously saved configuration can be loaded and activated on the IPBS/IPBL. See
Backup
on page 132 for information on how to save a configuration.
1. Select Update > Config.
2. Click "Browse..." and browse to the saved configuration.
3. Click "Upload".
4. Reset in order to make the changes take effect, see
Considerations when updating of configuration
Configuration files are only fully compatible if the backup and restore are done on products that
have CPUs with the same endianess. Both IPBS1 and IPBL have "big-endian" CPUs compared
to IPBS2 which have "little-endian" CPU. Hence, IPBS1 and IPBL are compatible.
If a device (e.g. IPBS2) is configured and the configuration is taken from another type of device
(e.g. IPBS1), some lines in the configuration will be skipped by the configured device (IPBS2).
This is because devices of different types do not have the same hardware and some
configuration lines are therefore not applicable in the configured device (IPBS2).
Update Firmware
Updated software files are distributed by your supplier.
There are two ways to update the firmware:
Using an update server, see
l
page 153.
Manual update, see below.
l
Avaya 374x DECT Telephones - User Guide
Appendix A: How to Configure and Use the Update Server
Reset
on page 141.
Operation
on
133
02/2016
Hide quick links:
Advertisement
Table of Contents
