Avaya IPBS1 Installation And Operation Manual page 23

Power Distribution
The DB1 can be powered using the following methods:
From the IPBL via the Express Powering Pair (EPP) and data pairs
l
With a local AC-adapter
l
Note: For more information about power distribution, see
Software
The software in the DB1 can be updated by downloading new software without disconnecting
the equipment. The new software is stored in flash memory. See
and DB1 on page 132 for information.
Connectors
Two 8-pin RJ45 modular jacks for data and powering
l
LEDs
The IPBS2 has one RGB LED to indicate status. This section describes the different indications
and when they shall be used. In the illustrations below: Each blink pattern is represented by a
number of blocks where each block is 100 ms. Light grey blocks means that the LED is off.
Whenever the indication is changed the new pattern always starts from the first block.
Idle/OK
Starting up
Active traffic
Fully occupied for
speech traffic
Software download 400 ms blue, 600 ms off.
Avaya 374x DECT Telephones - User Guide
Solid blue.
100 ms blue, 100 ms off.
400 ms off, 2000 ms blue.
400 ms red, 2000 ms blue.
Power the Base Station on page 44.
System Downgrade for IPBS2
DB1 operational and no traffic
on the DB1.
The DB1 is in start-up phase,
i.e. waiting to be initialized by
the IPBL.
DB1 operational and traffic on
the DB1.
Fully occupied with traffic.
Download of firmware in
progress.
Description
23
02/2016