5. The Radio restarts and it establishes a connection to the Master only.
Delete Radios
In the Static Registrations section, initialized Radios no longer registered to the Master are
shown.
1. Select Device Overview > Radios
2. In the Static Registrations section, click "Delete" to delete the Radio.
The Radio's RFPI is now released and can be reused. All other RFPIs in use are not affected.
Move RFPIs
In the Static Registrations section, initialized Radios no longer registered to the Master are
shown. If it is vital that the new device keeps the RFPI for the broken device e.g. alarm
localization purposes, move the RFPI for the broken device to the new device registered to the
Master.
1. Connect the replacing device.
2. Add the Radio to the Master, see
3. Select Device Overview > Radios
4. In the Static Registrations section, click "Move" for the Radio that is broken.
5. In the Move RFPI window, select in the Destination section the new Radio that you want to
move the broken Radio's RFPI to.
6. Click "Move".
Existing RFPI on the new Radio is replaced by the broken Radio's RFPI. The new Radio's RFPI
is now released and can be reused. All other RFPIs in use are not affected. The broken Radio
will be deleted from the Static Registrations section.
RFPs
This section only applies to the IPBL.
Information about the DECT devices connected to the IPBL. For explanation on the information,
see the table below.
1. Select Device Overview > RFPs.
2. Click the applicable port to open the RFP details pop-up window.
3. The following actions are available:
Click "OK" to save your settings and close the pop-up window.
l
Click "Cancel" to close the pop-up window.
l
Avaya 374x DECT Telephones - User Guide
Add Radios
on page 122.
Operation
123
02/2016