Configure Gatekeeper - Avaya IPBS1 Installation And Operation Manual

"Active", if this IPBS/IPBL is the Master.
l
"Standby", if this IPBS/IPBL is the Standby Master.
l
"Deployment" is used for coverage test only. The speech from the handset is looped
l
back to the handset.
"Mirror", if this IPBS/IPBL is the Mirror. For information about Mirror devices, see the
l
system description for IP-DECT.
2. If you have selected the "Standby" mode enter the primary Master IP address in its text
field.
3. If you have selected the "Mirror" mode enter the IP address to the other Mirror Master in
the Mirror Master IP address text field.
For the Master that initially shall be the active Mirror: Click on the text link "Activate mirror".
Any user and handset data in the inactive Mirror will be replaced with the user and handset
data stored in the active Mirror.
To switch the active role between the Mirror Masters, click on the text link "Switch active
mirror". Note: This should be done within a maintenance window as all active calls will be
lost.
4. Click "OK".
5. Reset in order to make the changes take effect, see

Configure Gatekeeper

Only applicable on the Master.
1. Select DECT > Master
2. Set Master ID
3. NOTE: The ID for the Master and the Standby Master must be identically.
4. Select PBX.
Note: If a redundant trunk shall be configured for connection to IPO PBX, select the PBX Resiliency
check box.
The PBX Resiliency check box will be disabled (greyed out) when Provisioning is enabled in the IPBS/
IPBL. About Provisioning, see
5. Select Protocol.
6. Enter ARS Prefix. For example, 00 for external calls.
7. Enter International CPN Prefix. For example, 0046 for Sweden.
8. Enter National CPN Prefix. For example, 031 for Gothenburg.
104
Avaya 374x DECT Telephones - User Guide
Provisioning on page 89.
Reset on page 141.
02/2016