Connect The Base Station Cables - Avaya IPBS1 Installation And Operation Manual

Pin the BS3x0/DB1 Cable
IMPORTANT: If local power supply is used, the EPP cable pair must NOT be connected.

Connect the Base Station Cables

1. Only for IPBS1: If it is required that the cables enter the base station centrally from above,
guide the cables through the recess in the middle of the base station as shown below.
1
2. Plug the modular jack of the data cable into one of the data/power connectors.
3. When an AC-adapter is used:
Plug the modular jack of the AC-adapter in one of the data/power connectors.
l
Plug the AC-adapter into a wall-outlet.
l
Avaya 374x DECT Telephones - User Guide
Figure 11.
RJ45
modular jack
1 2
Figure 14. Connector pinning of the Data connector
2
3 4 5 6 7 8
SC = Serial Channel
EPP = Express Power Pairs
NC = Not Connected
Installation of the Base Station
02/2016
43