Avaya IPBS1 Installation And Operation Manual page 146

Standby master active (Master)
User registration failure (Master)
Connection to Radio lost (Master)
Primary/redundant trunk is down (Master)
Master active (Master)
This event is generated when the Mirror becomes
active.
Master inactive (Master)
This event is generated when the Mirror becomes
inactive.
Limit of static radios is reached (Master)
This is an alarm which is generated when the
number of radios in the radios list (Device
Overview > Radios) is reaching 2100. The alarm is
cleared once the number of radios goes below 2100.
No Media data received (RTP)
No RTP packets from remote side were received on
a connected call. This points to either a NAT
problem (private RTP address was given to remote
side) or a general signaling problem (media
negotiation).
Excessive loss of data (RTP)
This event is generated if in a period of 10s more
than 3% received RTP packets were lost. This is an
indication of a network problem and it is
recommended to check the involved media IP
addresses and what kind of device that is involved.
Wrong payload type received (RTP)
Caused by signaling/negotiation problems
(interoperability). An endpoint sends RTP packets
with a payload type other than negotiated. Wrong
Payload Type is a message if there is a Media
Problem with a another PBX.
Stun failed (RTP)
Unexpected message (H323)
A message was received, which was not expected
by the protocol in this state. This could be caused
by network problems or by incompatible
equipment.
Status inquiry (H323)
146
Avaya 374x DECT Telephones - User Guide
0x00030201 IPBS/
IPBL
0x00030202 IPBS/
IPBL
0x00030204 IPBS/
IPBL
0x00030205 IPBS/
IPBL
0x00030206 IPBS/
IPBL
0x00030207 IPBS/
IPBL
0x00030208 IPBS/
IPBL
0x00050001 IPBS/
IPBL
0x00050002 IPBS/
IPBL
0x00050003 IPBS/
IPBL
0x00050004 IPBS/
IPBL
0x00060001 IPBS/
IPBL
0x00060002 IPBS/
IPBL
X
X
X
X
X
X
X
X
X
X
X
X
X
02/2016