Configure Microsoft Iis As An Update Server - Avaya IPBS1 Installation And Operation Manual

Installation and Operation Manual
Avaya IP-DECT Base Station & IP-DECT Gateway version 7.2.x
The command above specifies the url to the RFP firmware to use.
mod cmd RFP_UPDATE0 select 0x2753
Specifies which RFPs to update using a hex-encoded bit-mask. Each bit represents an RFP port
starting with port 1 at the LSB (0x0001) up to port 16 (0x8000).
0x2753 specifies RFP "1,2,5,7,9,10,11,14" to be updated.
mod cmd RFP_UPDATE0 schedule DD.MM.YYYY-HH:MM
Specifies when the update shall start. If no date is provided, the update will be immediate when
the start command is issued.
mod cmd RFP_UPDATE0 start /idle
Starts the update or activates the schedule. Normally the /idle command is selected and an
update starts only if the RFP is idle.
If multiple RFPs are selected for update, they will be updated one at a time If /sequence
command is used.
Example Update RFP Firmware
This example shows an "update file" for the IPBL.
mod cmd UP1 check ser 20070316-1
mod cmd RFP_UPDATE0 firmware http://172.20.8.125/ascom/rfp/
Worf123.S2
mod cmd RFP_UPDATE0 select 0xffff
mod cmd RFP_UPDATE0 start /idle
A.9

Configure Microsoft IIS as an Update Server

To be able to upload (save) device configuration information on the web server, it must allow
HTTP PUT requests. All other functions require HTTP GET permissions only.
You may want to restrict access to that site to certain network address ranges.
To avoid entering authentication data in every IPBS/IPBL, it is recommended to allow
anonymous read access. For write access (http PUT), authentication is needed with IIS ver. 6
and later. Authentication data needs to be configured in the devices that need to be backed up,
e.g. the PARI Master, Master and Mobility Master.
Requirements for IP-DECT
• Version 5.1.X and later supports the authentication algorithm "md5-sess".
Requirements for Microsoft IIS
• Must be a Windows 2008 R2 server containing Microsoft IIS ver. 7.5.
To configure Microsoft IIS as an Update Server
The steps that are involved are shown in the figure below. The steps are described in more detail
below the figure.
February 2016 157