Avaya IPBS1 Installation And Operation Manual page 169

Installation and Operation Manual
Avaya IP-DECT Base Station & IP-DECT Gateway version 7.2.x
Default
coder
VLAN ID
VLAN
Priority
TOS Bits
Enbloc
dialling
February 2016
String No 203
Word (16bit) No 206
Byte (8bit) No 207
String No 208
Byte (8bit) No 209
Defines the preferred This string option must
coders for H.245 coder contain the value of the
negotiation, as well as "/coder" option in the
the packet size when configuration file, e.g.
sending RTP packets G729A,40,esx.
and the use of CNG and Additional options are: e
VAD. - Exclusive, s - Silence
Compression, x - Enable
Secure RTP (SRTP), n -
No DTMF Detection.
The 802.1q VLAN ID Enter the numerical ID
for traffic sent and into the 16bit edit field
received by the device
The 802.1p VLAN Enter the numerical
priority for traffic sent priority into the 8bit edit
by the device field
The values for the IP Enter the comma
TOS/DSCP field in the separated numerical
IP header of UDP-RTP priorities into the string
and TCP-signalling field. You may prefix
packets sent by the with 0x to specify
device (Bit 0..2 hexadecimal numbers
'precedence', bit 3..6 (or 0 to specify octal
'type of service') numbers). The default
for RTP packets is 0xb8
(RFC 3246 - Expedited
Forwarding), for
signalling packets it is
0x68 (RFC 3246 -
Assured Forwarding).
0xb8,0x68 for example
defines the default
values
The number of seconds Enter the number of
dialled digits are kept in seconds into the 8bit
IP-DECT before they edit field. A value of 0
are sent en-bloc to the indicates that en-bloc
gatekeeper dialling is turned off and
digits are sent to the
gatekeeper as they are
dialled
169