Set A Static Ip Address - Avaya IPBS1 Installation And Operation Manual

Disabled
Client
Automatic
Change DCHP mode following the steps below.
1. On the IPBS: Select LAN > DHCP.
On the IPBL: Select LAN1 > DHCP.
2. Select DCHP mode in the Mode drop-down list.
3. Click "OK".
4. If "Client" or "Automatic" is set, reset to make the changes take effect. See
page 141.

Set a Static IP Address

It is necessary for the Master and the Standby Master to have static IP addresses. The Slaves
can have dynamic IP addresses retrieved from the network DHCP server.
Ask the network administrator to reserve an IP address for the Master and Standby Master.
1. On the IPBS: Select LAN > DHCP.
On the IPBL: Select LAN1 > DHCP.
2. Select "Disabled" in the Mode drop-down list.
3. Click "OK".
4. Do NOT reset the device yet. Set a static IP address first.
5. On the IPBS: Select LAN > IP.
On the IPBL: Select LAN1 > IP.
6. Enter "IP Address", "Network Mask", "Default Gateway" and "DNS Server" addresses
provided by the network administrator in the text fields.
7. You can also enter an alternative DNS Server in the Alt. DNS Server text field and select
the Check ARP check box to detect and prevent ARP poisoning attacks.
8. Click "OK".
9. Reset in order to make the changes take effect, see
10. Start the web-based configuration, using the static IP address.
92
Avaya 374x DECT Telephones - User Guide
Figure 16.
Used if the IPBS/IPBL should have a static IP address.
The IPBS/IPBL acts as a DHCP Client, if there is a DHCP server
in the network it will be assigned an IP address
In automatic DHCP mode the IPBS/IPBL will act as a DHCP
client on power up.
If the IPBS/IPBL is restarted by shortly pressing the reset button it
will get the IP address 192.168.0.1 and the netmask 255.255.255.0
for the LAN1 port.
Reset on page 141.
Reset on
02/2016