Configure The Master - Avaya IPBS1 Installation And Operation Manual

Configure the Master

This section describes how to configure the Master. Each configuration step is briefly described
in the step list below. For more detailed information see the corresponding subsection in
Operation on page 71.
1. Determine the address and access the GUI, see
2. Change the default password, see
Note: This step is not needed if the Master is configured as Mirror. In that case, jump to the next step.
Configure LDAP user name and password, select the Write Access check box, see
Server
3. Set a static IP address and set DHCP to off, see
4. Set the mode to Active or Mirror, see
5. Perform a reset to restart the IPBS/IPBL in Master mode, see
6. Select DECT > System and enter password.
7. Select system name and password, see
page 99.
8. Set default language, see
9. Select supplementary services, see
10. Set frequency band, see
11. Configure the Master settings, see
12. Set the Master IP address to 127.0.0.1, see
13. Perform a reset to restart the IPBS/IPBL in Master mode, see
If problem to access the Master from a certain PC after the reset;
Open a command window in windows by selecting Start > Run and enter "cmd" in the
l
Open: text field.
Enter the following commands
l
Restart the web browser.
l
14. Select supplementary services, see
15. Assign PARI, see
16. Enter SARI, see
17. Enter AIWS2 IP address, see
64
Avaya 374x DECT Telephones - User Guide
on page 96.
Set Default Language
Set Frequency Band
arp -d
nbtstat -R
PARI on page 108.
SARI on page 108.
Configure Messaging
Access the GUI
Change the Default Password
Set a Static IP Address
Select Mode on page 103.
Change System Name and Password
on page 100.
PARI on page 108.
on page 100.
Configure Gatekeeper
PARI on page 108.
(Delete the arp cache)
(Empty the nbtstat cache)
PARI on page 108.
on page 53.
on page 56.
Reset on page 141.
on page 104.
Reset on page 141.
on page 111
Configure LDAP
on page 92.
on
02/2016