Configure The Slave/Radio - Avaya IPBS1 Installation And Operation Manual

Enter the following commands
l
arp -d(Delete the arp cache)
nbtstat -R(Empty the nbtstat cache)
Restart the web browser.
l

Configure the Slave/Radio

This section describes how to configure the Slave. Each configuration step is briefly described
in the step list below, for more detailed information see the corresponding subsection in
Operation on page 71.
Note: When one Slave is configured, the configuration can be saved and uploaded to the other Slaves
in the system.
1. Determine the address and access the GUI, see
2. Change the default password, see
3. Set DHCP mode to "Client", see
4. Enable the Radio in the IPBS/IPBL, see
5. If the radio acts as a Standby Master, perform the following:
6. Configure LDAP replicator, enter the IP address, user name and password to the LDAP
server and the alternative LDAP server. Check the Enable check box, see
LDAP Replicator
7. Enter the system name and password, this must be the same system name and password
as in the Master, see
8. With LDAP replication enabled, the password will be verified against the Master. If the
password is wrong a single dot (.) will appear in the text field.
9. Set the mode to Slave, see
10. Enter Master and Standby Master IP addresses, see 7.5.14 Enter IP Address to the Pari
Master on page 63.
11. Configure air synchronization, see
12. Enter the Time Server address, see
13. Reset in order to make the configuration changes take effect, see
14. Save the configuration of the Slave, see
Configure the rest of the IPBS/IPBL following the steps below:
Note: Uploading the same configuration to all slaves can only be done if the DHCP is set to client.
15. Determine the address.
66
Avaya 374x DECT Telephones - User Guide
Change the Default Password
Dynamic IP address using DHCP
on page 97.
Change System Name and Password
Select Mode
PARI on page 108
Configure Air Synchronization
Trust List
Access the GUI
Enable the Radio on page 107.
on page 99.
on page 103.
on page 84.
Backup on page 132.
on page 53.
on page 56.
on page 93.
Configure
on page 109.
Reset on page 141.
02/2016