Installation Of The Ipbl - Avaya IPBS1 Installation And Operation Manual

Installation of the IPBL

This section describes how to install the IPBL.
Install the IPBL
The main steps of the installation is described below:
1. Install the IPBL in a standard 19'' rack.
2. Pin the cables, see
3. Attach the power cable, see
4. Connect the cables in the following order:
Ethernet cable (A) LAN1 port must be used in the IP-DECT system (LAN2 port is for
l
administration only).
Synchronization cable (ring sync, reference sync) (B)
l
Base station cable (RFP cable) (C)
l
IMPORTANT: The connected RFPs must not be connected to protective earth.
Monitor the total current consumption from the GUI. See
l
sure it not exceeds the following values:
Avaya 374x DECT Telephones - User Guide
LAN Synchronization
IP DECT Gateway
1 2 ring in
A
Figure 16. Install the IPBL
Pin the IPBL Cable
Power the IPBL
Base Station 01
Reference
ring out in out 09
B
on page 48.
on page 50.
Installation of the IPBL
02 03 04 05 06 07 08
10 11 12 13 14 15 16
C
Environment on page 140. Make
47
02/2016