Paradyne 9126 User Manual page 277

Table 8-1.
9128-A2-GB20-80
Alarm Conditions (7 of 7)
Alarm Condition What It Indicates
Suboptimal Link Rate, The specified frame relay
2
frame relay link
multilink has failed to
achieve the configured
Maximum Link Rate for the
link.
This message appears for
multilink aggregate frame
relay links if LMI is down on
any of its constituent links.
Two Level-1 Users Another user with Level-1
Accessing Device security access is currently
accessing the unit.
Be aware that actions of the
other user may override
your test commands and
configuration changes.
Yellow at DSX-1 A yellow alarm signal is
received on the DSX-1
interface. DTE has detected
a LOS or OOF condition.
Yellow at Network 1 A yellow alarm signal is
received on the network
interface.
T
T
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n . The frame relay link associated with a user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Access Management Link DLCI.
September 2002
What To Do
No action required.
Wait until no other Level-1 users
are accessing the unit if testing or
configuration will be performed.
T
T
T
Network cable problem.
T
T1 facility problem.
8. Troubleshooting
Check that the DSX-1 cable is
securely attached at both ends.
Check the status of the
attached equipment.
Check that your network cable
is securely attached at both
ends.
Contact your network provider.
8-13