Paradyne 9126 User Manual page 173

Limiting FTP Access
FTP access can be limited by:
T
T
T
Procedure
To limit FTP access when the session is not on the TS Access Management Link:
See
Options, for more information about setting FTP configuration options.
9128-A2-GB20-80
Disabling FTP access completely.
Requiring a user ID and password to login.
Limiting FTP bandwidth.
1. Select the Telnet and FTP Session options.
Main Menu Configuration
Telnet and FTP Sessions
2. Set the following configuration options, as appropriate.
To . . .
Disable FTP
Require a login
Limit bandwidth for FTP
3. Save your changes.
Configuring Telnet and/or FTP Session Support
September 2002
Management and Communication
Set the configuration option . . .
FTP Session to Disable.
Login Required to Enable.
NOTE: User ID and password combinations must
be defined. See Creating a Login
If you want to allow users to configure the unit or
perform file transfers, including downloads, keep
the access at Level-1.
Level-1 access is required to download software to
the unit, or to upload or download configuration
files. Level-3 is sufficient for NMS access for SLV
historical information.
FTP Max Transfer Rate to a rate less than the
network line speed, typically less than or equal to
the CIR.
T
his method is not recommended if SLV reports are
desired since FTP is required to generate the
reports.
in Chapter 4, Configuration
6. Security and Logins
on page 6-12.
6-7