Paradyne 9126 User Manual page 203

Table 7-8.
9128-A2-GB20-80
Health and Status Messages (2 of 7)
Message
DBM Download Required
(ISDN BRI DBM only)
DCLB Active, [Interface]
DLCI nnnn Down,
1,2
frame relay link
DTE External LB Active, Port- n
DTE Init. Ext LB Active, Port- n
DTPLB Active, Port-2
DTR Down from Port-1 Device
EER at ISDN PRI (Active/Idle)
(ISDN PRI DBM only)
EER at Network 1
Ethernet Link Down
(FrameSaver SLV 9126-II or
9128-II)
Internal Modem Failed
ISDN Active
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n . The frame relay link associated with the user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Management Link DLCI.
September 2002
7. Operation and Maintenance
What It Indicates
A download attempt was interrupted and failed to
complete.
The NAM software and DBM software are
incompatible.
A V.54 Loopback is active on the specified interface.
The DLCI for the specified frame relay link is down.
A Data Terminal Loopback is running on the
specified user data port.
The DTE has initiated an external DTE Loopback on
the specified user data port.
A Data Terminal Payload Loopback (DTPLB) is
active on the synchronous user data port.
The DTR control lead from the device connected to
the user data port is deasserted.
The error rate of the received ISDN network signal
exceeds the currently configured threshold. This
condition only occurs if the network interface is
configured for ESF framing and a PRI dial backup
module (DBM) is installed.
T
Active – Backup call was in progress.
T
Idle – DBM was in Idle mode.
This condition clears when the error rate falls below
the threshold value, which may take up to
15 minutes.
The error rate of the received network signal
exceeds the currently configured threshold. This
condition only occurs if the network interface is
configured for ESF framing.
This condition clears when the error rate falls below
the threshold value, which may take up to
15 minutes.
The Ethernet port is enabled, but communication
between the management system and the unit is not
currently possible on the port.
The unit's internal modem failed to pass the self-test.
An ISDN call is active.
7-21