Paradyne 9126 User Manual page 207

Table 7-8.
9128-A2-GB20-80
Health and Status Messages (6 of 7)
Message
RLB Active, [Interface]
Secondary Clock Failed
Send Pattern Active, DLCI nnnn ,
1,2
frame_relay_link
Send Pttn Active, [Interface]
SLV Latency Exceeded,
DLCI nnnn , frame relay link
SLV Timeout, DLCI nnnn ,
1, 2, 3
frame relay link
Suboptimal Link Rate,
2
frame relay link
(ISDN DBM only)
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n . The frame relay link associated with the user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Management Link DLCI.
September 2002
What It Indicates
A network Repeater Loopback (RLB) is active on the
specified interface.
A failure of the secondary clock source configured for
the unit is detected and the internal clock is providing
the timing for the unit.
The clock source will not automatically switch from
internal until the primary clock source returns.
A Send Pattern test is currently active on the
specified DLCI on the specified frame relay link.
A Send Pattern test is active on the specified
interface using a selected test pattern.
This test cannot be activated on user data ports that
have Port Use set to Frame Relay.
The measured latency of SLV communication
1, 2, 3
responses from the remote unit on this DLCI is
excessive, so the DLCI has been declared unsuitable
for normal multiplexed PVC operation (DLCI Type is
set to Multiplexed).
An excessive number of SLV communication
responses from the remote FrameSaver SLV unit
have been missed on the specified multiplexed DLCI;
the DLCI is not suitable for user data.
When a hardware bypass capable device has been
detected at the other end of the PVC and this
condition occurs, only user data for EDLCI 0 will be
transmitted while this condition exists.
When an ISDN DBM is present, this message only
appears for individual and aggregate multilink frame
relay links, not constituent links of a frame relay
multilink.
The specified frame relay multilink has failed to
achieve the configured Maximum Link Rate for the
link.
This message appears for multilink aggregate frame
relay links if LMI is down on any of its constituent
links.
7. Operation and Maintenance
7-25