Paradyne 9126 User Manual page 197

Table 7-6.
9128-A2-GB20-80
Device Messages (4 of 6)
Message What It Indicates
No DLCIs Available for New was selected from the
Mgmt PVC Management PVCs option
screen, but all configured
DLCIs have been
connected.
No DLCIs Defined DLCI Records was selected
from an interface's
Configuration Edit/Display
menu, and no DLCI
Records have been created
for this interface.
No more DLCIs New or CopyFrom was
allowed selected from an interface's
DLCI Records configuration
screen, and the maximum
number of DLCI Records
had already been reached.
No Primary New or Modify was selected
Destination Link DLCIs from the PVC Connection
Available Table, but even though
DLCIs are available to form
a connection, no DLCIs are
available on the network
link, which is a suitable
Primary PVC Destination.
No Security Records Delete was selected from
to Delete the Administer Login
screen, and no security
records had been defined.
Password Matching Password entered in the
Error – Re-enter Re-enter Password field of
Password the Administer Logins
screen does not match what
was entered in the
Password field.
Permission Denied A file transfer was
attempted, but the:
(Seen at an FTP
T
terminal.)
T
T
September 2002
What To Do
Configure more network and/or
Port-1 DLCIs and try again.
Select New and create a DLCI
record.
Delete a DLCI, then create the
new DLCI Record.
Configure additional DLCIs for the
network link and try again.
If a network DLCI has been
entered as a Source DLCI:
1. Change the Source DLCI to a
2. Enter the network DLCI as the
T
T
T
T
T
User did not have Level
1 security.
T
Wrong file was specified
when the put command
was entered.
T
User attempted to
upload a program file
from the unit.
7. Operation and Maintenance
user data port DLCI.
PVC's Primary Destination.
No action needed.
Enter a security record.
Try again.
Contact your system
administrator to verify your
password.
See your system administrator
to get your security level
changed.
Try again, entering the correct
file with the put command.
Enter the put command
instead of a get command; you
can only transfer files to the
unit, not from it.
See Upgrading System
Software on page 7-77.
7-15