Paradyne 9126 User Manual page 198

7. Operation and Maintenance
Table 7-6.
7-16
Device Messages (5 of 6)
Message What It Indicates
Please Wait Command takes longer
than 5 seconds.
Port Inactive The port is disabled, or it
supports synchronous data
(FrameSaver SLV
when a DTE Loopback was
9128-II only)
started.
Resetting Device, Yes (or y) was entered in
Please Wait ... the Reset COM Port usage
field of the System Paused
menu.
Save Cancelled Changes were made on the
Easy Install screen, but
(FrameSaver SLV
when it came to saving the
9128-II only)
changes, the Esc key was
pressed or No was entered
in response to the Save
Changes? prompt.
Test Active No higher priority System
and Test Status messages
exist, and a test is running.
User Interface Already Two Telnet sessions are
in Use already in use when an
attempt to access the
menu-driven user interface
through the COM port is
made.
IP addresses and logins of
the users currently
accessing the interface are
also provided.
User Interface Idle Previously active session is
now closed/ended, and
access via the COM port is
now available.
Session has been ended
due to timeout.
September 2002
What To Do
Wait until message clears.
No action is needed.
No action needed.
No action is needed.
T
Contact service provider if test
initiated by the network.
T
Wait until the test ends and
message clears.
T
Cancel all tests from the Test
screen (Path: main/test).
T
Stop the test from the same
screen the test was started
from.
T
Wait and try again.
T
Contact one of the IP address
user and request that they log
off.
Log on to the FrameSaver unit.
No action needed.
9128-A2-GB20-80