Paradyne 9126 User Manual page 191

Table 7-1.
9128-A2-GB20-80
General Status LEDs (2 of 2)
Label Indiction
ALM Operational
Alarm (Fail)
(cont'd)
TST Test Mode
BKP Backup
FR Frame Relay
2
Mode Mode
(Model
9128-II
only)
1
When an ISDN BRI DBM is installed, if the OK LED comes on then goes off during
power recycling, the ISDN BRI DBM may have failed.
2
On the Display LEDs & Control Leads screen for the Model 9128-II only, FR Mode
is On or Off. When On (highlighted), the FrameSaver unit is in Frame Relay mode.
September 2002
Color What It Means
Red ON – FrameSaver unit has just been reset, or an
error or fault has been detected.
Alarms appear on the System and Test Status
screen. See Table 7-8, Health and Status
Messages, for additional information.
OFF – No failures have been detected.
Yellow ON – Loopback or test pattern is in progress,
initiated locally, remotely, or from the network.
OFF – No tests are active.
Yellow ON – FrameSaver unit is in Backup mode; that
is, the backup link has been established, and
backup is in progress through the specified
Alternate Destination Link.
OFF – FrameSaver unit is not in Backup mode.
Blinking ON and OFF – Alternate Destination
Link is being established, but no data has been
passed.
Multi- Yellow – LMI is down on the FrameSaver
colored SLV 9128-II.
Green – LMI is up on the FrameSaver
SLV 9128-II.
7. Operation and Maintenance
7-9