Paradyne 9126 User Manual page 204

7. Operation and Maintenance
Table 7-8.
7-22
Health and Status Messages (3 of 7)
Message
ISDN Link Profile Disabled
ISDN Link Name
ISDN Link Profile Invalid,
ISDN Link Name
ISDN Network Failed (Active/ Idle)
LatExceed IP_ Address,
1
COS x, DLCI nnnn
Link Down Administratively, frame
2
relay link
Link Profile Disabled,
ISDN Link Name
LLB Active, [Interface]
LMI Discovery in Progress, frame
2
relay link
2
LMI Down, frame relay link
LOS at DSX-1
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n . The frame relay link associated with the user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Management Link DLCI.
September 2002
What It Indicates
An ISDN backup call could not be made because the
ISDN link profile specified Link Name is disabled
( Main Menu Configuration
Link Profiles) .
No phone numbers have been specified in the ISDN
link profile (specified by ISDN Link Name ).
An ISDN network failure was detected when:
T
Active – Backup call was in progress.
T
Idle – DBM was in Idle mode.
An IP SLV Latency Threshold has been exceeded for
the specified COS of the path. IP_Address is the IP
address of the path endpoint, COS x is the Class of
Service ID associated with the path, and nnnn is the
DLCI which contains the path.
The specified frame relay link has been disabled by
the unit due to LMI Behavior conditions or LMI
Protocol on another link is in a failed state.
An ISDN backup call could not be made because the
specified link profile was disabled.
A network Line Loopback (LLB) is active on the
specified interface.
Local Management Interface protocol discovery is in
progress to determine which protocol will be used on
the specified frame relay link.
The Local Management Interface(s) has been
declared down for the specified frame relay link.
T
For an individual ISDN link, the message appears
when LMI has been declared down on the link.
T
For a multilink aggregate link, the message
appears when LMI has been declared down on all
constituent links of the frame relay multilink.
A Loss of Signal (LOS) condition is detected on the
DSX-1 interface. Clears when the ratio of ones to
zeros received is greater than or equal to 12.5%.
Possible reasons include:
T
DSX-1 cable problem.
T
No signal being transmitted from the DTE.
ISDN
9128-A2-GB20-80