Paradyne 9126 User Manual page 192

7. Operation and Maintenance
Table 7-2.
Table 7-3.
Table 7-4.
7-10
Network, DSX, or PRI Interface LEDs
Label Indication
SIG Signal
OOF Out of Frame
ALM Alarm
User Data Port LED (CSU/DSUs Only)
Label Indication
1
OK Operational
Status
1
The FrameSaver SLV 9128-II only has one OK LED even though it has two user
data ports. If either port is enabled and active, the LED is on. If both ports are
enabled and one of the ports is inactive, the LED is off.
Ethernet Port LED (Routers Only)
Label Indication
OK Operational
Status
September 2002
Color What It Means
Green ON – A recoverable signal is present on the
Network/DSX/PRI interface.
OFF – The signal cannot be recovered from the
Network/DSX/PRI interface. An LOS condition
exists.
Yellow ON – At least one OOF was detected during the
sampling period.
OFF – No OOFs were detected during the
sampling period.
Yellow ON – An alarm condition is present on the
network/DSX/PRI interface.
Current alarm conditions:
T
Loss of Signal (LOS)
T
Loss of Frame (LOF)
T
Out of Frame (OOF)
T
Excessive Error Rate (EER)
T
Yellow Alarm Signal
T
Alarm Indication Signal (AIS)
OFF – No alarm condition is present on the
Network/DSX/PRI interface.
Color What It Means
Green ON – The interchange circuits for the port are in
the correct state to transmit and receive data.
OFF – The port is idle. Occurs if the port is
disabled, or if the port is configured to monitor
DTR and/or RTS and the lead(s) is not asserted.
Color What It Means
Green ON – The Ethernet port is transmitting and
receiving.
OFF – The port is idle.
9128-A2-GB20-80