Paradyne 9126 User Manual page 209

Test Status Messages
These test messages appear in the right column of the System and Test Status
screen. You have the option of allowing the test to continue or aborting the test.
See
start and stop them.
Table 7-9.
9128-A2-GB20-80
Chapter 8, Troubleshooting, for more information on tests, including how to
Test Status Messages (1 of 2)
Message
DCLB Active, frame_relay_link
DCLB Active, Port-2
DTE External LB Active, Port- n
DTE Init. Ext LB Active, Port- n
DTPLB Active, Port- n
Lamp Test Active
2
LLB Active, Interface
No Test Active
2
PLB Active, Interface
PVC Loopback Active, DLCI nnnn ,
1 ,3
frame_relay_link
2
RLB Active, Interface
2
Send Pttn Active, Interface
1
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n for a 1-slot unit, or S s Port- n for a NAM in a multislot housing (the frame relay
link associated with the specified user data port in the specified slot).
– ISDN Link Name on a non-network ISDN DBM interface.
2
Interface is one of the following:
– Network 1
– DSX-1
– Port- n
– ISDN, BRI or PRI
3
nnnn indicates a DLCI number of 16 through 1007.
September 2002
What It Indicates
1
or A Data Channel V.54 Loopback (DCLB) is active on
the specified frame relay link, or Port-2.
An external DTE Loopback is active on the user
data port.
An external DTE Loopback is active on the user
data port.
A Data Terminal Payload Loopback (DTPLB) is
active on the user data port.
The Lamp Test is active, causing the LEDs on the
faceplate to flash on and off.
A network Line Loopback (LLB) is active on the
specified network, DSX-1, or ISDN PRI interface.
No tests are currently running.
A Payload Loopback (PLB) is active on the
specified network, DSX-1, or ISDN PRI interface.
A PVC Loopback is active on the specified DLCI for
the frame relay link.
A network Repeater Loopback (RLB) is active on
the specified network or DSX-1 interface.
A Send Pattern test is active on the specified
interface.
This test cannot be activated on user data ports that
have Port Use set to Frame Relay.
7. Operation and Maintenance
7-27