Paradyne 9126 User Manual page 272

8. Troubleshooting
Table 8-1.
8-8
Alarm Conditions (2 of 7)
Alarm Condition What It Indicates
EER at Network 1 The error rate of the
received network signal
exceeds the currently
configured threshold. This
condition only occurs if the
network interface is
configured for ESF framing.
This condition clears when
the error rate falls below the
threshold value, which may
take up to 15 minutes.
Ethernet Link Down The communication link for
the Ethernet port is down
and the Interface Status for
the port is enabled.
Internal Modem Failed The unit's internal modem
failed to pass the self-test.
ISDN Link Profile An ISDN backup call could
Disabled ISDN Link not be made because the
Name ISDN link profile specified
Link Name is disabled
( Main
Menu
ISDN
ISDN Link Profile An ISDN backup call could
Invalid, not be made because the
ISDN Link Name ISDN link profile specified
( ISDN Link Name ) is invalid.
ISDN Network Failed An ISDN network failure
(Active/Idle) was detected when a
backup call was in progress
or the DBM was in Idle
mode.
LatExceed- An IP SLV Latency
IP_Address,
Threshold has been
1
COS x, DLCI nnnn exceeded for the specified
Class Of Service of the
path.
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port- n . The frame relay link associated with a user data port.
– ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Access Management Link DLCI.
September 2002
What To Do
T
Verify that the network cable is
securely attached at the
network interface.
T
Contact your network provider.
Check the LAN connected to the
Ethernet port.
Reset the FrameSaver unit ( Main
Menu
If the modem fails again, contact
your service representative.
Enable the ISDN link profile if you
want to make a call.
Configuration
Link Profiles) .
Check that the phone number is
correct.
Contact your network provider if
the problem persists.
Contact your service provider.
Control Reset Device) .
9128-A2-GB20-80