Paradyne 9126 User Manual page 255

Placing a Test Call (Nondisruptive)
Use this procedure to test the ISDN path to each remote site. This procedure will
not put the system into backup.
Procedure
Use this procedure to test the ISDN path to each remote site. This procedure will
not put the unit into backup.
9128-A2-GB20-80
1. Make sure the ISDN Link Profiles and DLCIs are set up correctly for the DBMs
at each end (see Modifying ISDN Link Profiles
Options .
Main Menu Configuration
Main Menu Configuration
2. Place a Test Call from one of the devices.
Main Menu Test ISDN Call/PVC Tests
— Select the link to be tested.
— Start a Test Call. The Status should be Active.
If the Result is . . .
Frame Relay Link Up
Frame Relay Link Down
— Select Stop to end the Test Call.
September 2002
in Chapter 4, Configuration
ISDN Link Profiles
ISDN DLCI Records
Then . . .
The call was successful.
The call was not successful. Verify the configuration and
Link Status in the ISDN Link Profile.
7. Operation and Maintenance
7-73