Paradyne FrameSaver 9120 Installation Instruction Supplement

FrameSaver 1-Slot Unit
Installation Instructions Supplement
Document Number 9000-A2-GK42-00
May 1998
Introduction
Safety Instructions
Power Cords
Installing the Universal Power Supply
9000-A2-GK42-00
TM
The FrameSaver 9120 unit that you have received has been produced
especially for applications such as yours, where the Frame Relay network
access is via the T1 Network (NET) interface, the same as in North America.
However, your unit requires the Universal power supply, rather than the
power supply used in North America. Therefore, the connection and operation
procedures listed in the 1-Slot Assembled Access Unit Installation Instructions
(Document No. 9000-A2-GN10) are accurate for your application, but the power
supply shown is different.
Please read the EMI warning and Important Safety Instructions that come with
this unit, in the Universal Power Supply (220 Vac) Safety and Regulatory,
Warranty and Service Information (Document No. 9000-A2-GX43).
Refer to the following table to verify that you have the appropriate power cord for
the wall-plug standard in your country.
Country Plug Standard Part Number
Japan JIS 8303
Korea NEMA 5-15P
Refer to Universal Power Supply Installation Instructions (Document
No. 9000-A2-GN21).
125-0092-0031
125-0007-0031
May 1998
Power Cord Description
IEC 320-to-JIS 8303 – 2.5 m
IEC 320-to-NEMA 5-15P – 2.3 m
1