Paradyne 9126 User Manual page 174

6. Security and Logins
Limiting Telnet or FTP Access Over the TS Access Management Link
Procedure
To limit Telnet or FTP access when the session is on the TS Access Management
Link:
See
Information
configuration options.
6-8
1. Select the Telnet and FTP Session options.
Main Menu Configuration
Telnet and FTP Sessions
2. Disable Telnet Session and/or FTP Session, as appropriate.
3. Return to the Management and Communication menu, and select Node IP.
4. Set the following configuration options, as appropriate.
To . . .
Disable access via the TS
Access Management Link
Assign an access level to the
TS Access Management Link
5. Save your changes.
Configuring Telnet and/or FTP Session Support
in Chapter 4, Configuration Options, for more information about these
September 2002
Management and Communication
Set the configuration option . . .
TS Access Management Link to None.
TS Access Management Link's Access Level to
Level-2 or Level-3.
NOTE: Regardless of a user's login access level, a
user cannot operate at a level higher than the
access level specified for the session (e.g., if a user
has a Level-1 login and Level-2 telnet access has
been set, the Level-1 user can only operate as a
Level-2 user).
If you are going to allow users to configure the unit,
keep the access at Level-1.
or Configuring Node IP
9128-A2-GB20-80