Program 34 : Tie Line Setup; E&M Tie Line Basic Setup - NEC SL 1000 Programming Manual

ISSUE 3.01
Level:
IN
Description
Use Program 34-01 : E&M Tie Line Basic Setup to define the basic settings for each E&M Tie line.
Input Data
Trunk Port Number
Item Item
No.
01 DID/E&M Start
Signaling
02 Receive Dial
Type for E&M Tie
Line
03 E&M Dial-In
Mode
04 E&M Line Dial
Tone
05 System Toll Re-
striction
Conditions
None
Feature Cross Reference
None
Programming Manual

Program 34 : Tie Line Setup

34-01 : E&M Tie Line Basic Setup
Input Data
nd Set the start signaling mode for DID
0 = 2 Dial Tone
and Tie trunks. DID and Tie trunks
1 = Wink
can use either immediate start or
2 = Immediate
wink start signaling.
3 = Delay
0 = DP
1 = DTMF
0 = Specify Extension Determine if the incoming Tie Line
Number (Intercom) call should be directed as an inter-
1 = Use Conversion com call or if it should follow the DID
Table (NTT) Translation Table in Program 22-11.
0 = Disable (No) Enter 1 if the Tie Line should send
1 = Enable (Yes) dial tone to the calling system after
the call is set up. Enter 0 if the Tie
Line should not send dial tone.
0 = System Determine if an incoming Tie Line
1 = Each Extension call should be subject to Toll Re-
striction. If it is set to 0 then it will
use the Program 21-05-13, if it is set
to 1 then it will used Programs
21-05-01 ~ 21-05-13.
001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Description Default
SL1000/SL1100
Program
34
Related
Program
0 22-02
1 10-09
0 22-11
1
0 21-05
2-357