Single Line Telephone Basic Data Setup - NEC SL 1000 Programming Manual

ISSUE 3.01
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various single line
telephone options.
Input Data
Extension Number
Item Item
No.
01 SLT Signaling
Type
03 Terminal Type
04 Flashing
05 Trunk Polarity
Reverse
06 Extension Polari-
ty Reverse
07 Enabled On-
Hook When
Holding (SLT)
08 Answer On-Hook
when Holding
(SLT)
Programming Manual
Input Data
0 = DP Use this option to tell the system the
1 = DTMF type of dialing the connected tele-
phone uses.
For Analog Wireless telephones to
function correctly, this must be set
to 0 (dial pulse). If this option is set
for DTMF, after an outside call is
placed, the system cannot dial any
additional digits.
This program change is automatical-
ly performed when the Analog Wire-
less telephone is registered. When
upgrading software from prior ver-
sions, the previous default of 1 is
saved from the prior database so
this option must be changed man-
ually.
0 = Normal Enter 1 for this option to allow a sin-
1 = Special gle line port to receive DTMF tones
after the initial call setup. Enter 0 to
have the port ignore DTMF tones af-
ter the initial call setup. For Voice
Mail, always enter 1 (e.g., receive
DTMF tones).
0 = No Enables/disables Flash for single
1 = Yes line telephones.
0 = Off Do Not Change Default Entry as
1 = On DTMF issues may arise with voice
mail.
0 = Disable (Off) Do Not Change Default Entry as
1 = Enable (On) DTMF issues may arise with voice
mail.
0 = No
1 = Yes
0 = Disable (No)
1 = Yes (Enable)
Maximum four digits (SL1000)
Maximum eight digits (SL1100)
Description Default
SL1000/SL1100
Program
15
Related
Program
1 15-03-03
45-01-01
0 15-03-01
45-01-01
1
0
0
1 11-12-45
1 11-12-46
2-137