Internal Paging Group Settings - NEC SL 1000 Programming Manual

ISSUE 3.01
Level:
IN
Description
Use Program 31-03 : Internal Paging Group Settings to assign names to Internal Paging Groups
(i.e., Page Zones) and to define the splash tone for Internal Paging.
The system shows the names you program on the telephone display. Use the following chart when
entering and editing text. When using the keypad digits, press the key once for the first character,
twice for the second character, etc. For example, to enter a C, press 2 three times. Press 2 six times
to display the lower case letter.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
1 Enter characters : 1 @ [ ¥ ] ^ _ ` { | }
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
* Enter characters :
# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow soft key instead
to accept and/or add a space.)
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Internal Paging Group Number
Item Item
No.
01 Internal Paging Group
Name
Programming Manual
Program 31 : Paging Setup

31-03 : Internal Paging Group Settings

Key for Entering Names
When you want to ...
* + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
Input Data
Up to 12 Characters Assign name to Internal Paging Groups
(i.e., Page Zones). The system shows the
name you program on the telephone dis-
play.
Á À Â Ã Å Æ Ç É Ê ì ó 0
01 ~ 32
Description
SL1000/SL1100
Program
31
Default
Refer below
2-345