Vrs/Disa One-Digit Code Attendant Setup - NEC SL 1000 Programming Manual

SL1000/SL1100
Level:
IN
Description
Use Program 25-06 : VRS/DISA One-Digit Code Attendant Setup to set up single digit dialing
Program
through the VRS. This gives VRS callers single key access to extensions, the company operator,
Department Calling Groups and Voice Mail. For each VRS message set to answer outside calls (refer
25
to Programs 25-04 and 25-05), you specify:
• The digit the VRS caller dials (0 ~ 9,
outside callers cannot dial system extensions.
• The destination reached (Maximum four digits (SL1000) Maximum eight digits (SL1100)) when the
caller dials the specified digit.
The destination can be an extension, a Department Calling pilot number or the Voice Mail master
number. A one-digit code can be assigned for each Automated Attendant message.
Example:
Message Number = 01, Destination = 2, Next Message Number = 0, Dial = 399
In this example, when 2 is dialed by an outside caller, the system transfers the call to 399. This means
that extension 200~299 cannot receive calls from VRS/DISA users during/after VRS Message 01.
Input Data
Item
No.
01 Next Attendant Mes-
sage Number
02 Destination Number
2-306
Program 25 : VRS/DISA Setup

25-06 : VRS/DISA One-Digit Code Attendant Setup

*
Attendant Message Number
Received Dial
Item Input Data
0 ~ 100 (0 = No Setting)
101 = Voice Mail an-
swers
104 = Refer to
VRS/DISA Transfer Ring
Group With No Answer/
Busy on page 2-304
105 = Dial the other ex-
tension
106 =record VRS
Up to four digits
(SL1000)
Up to eight digits
(SL1100)
Must be a valid ex-
tension number that
is programmed in
command 11-02 or
11-04.
, #). Keep in mind that if you assign destinations to digits,
Description
Defines the next attendant message num-
ber or destination number for each 1-digit
access code in Automated Attendant serv-
25-04 : ice
ISSUE 3.01
01 ~ 100
1 ~ 9, 0, * , #
Default
No Setting
Program 25 : VRS/DISA Setup
0