Selectable Display Messages - NEC SL 1000 Programming Manual

ISSUE 3.01
Level:
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.
There are 20 alphanumeric messages, with up to 16 (SL1000) 48 (SL1100) characters. Use the
following chart when programming messages.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back
Flash
Input Data
Selectable Display Message Number
Item No. Item
01

Selectable Display Messages

Default
Number
1 IN MEETING UNTIL ## : ##
2 MEETING ROOM - ########
3 COME BACK ## : ##
4 PLEASE CALL ###########
Programming Manual
Program 20 : System Option Setup
20-16 : Selectable Display Messages
Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
Enter characters : A-C, a-c, 2.
Enter characters : D-F, d-f, 3.
Enter characters : G-I, g-i, 4.
Enter characters : J-L, j-l, 5.
Enter characters : M-O, m-o, 6.
Enter characters : P-S, p-s, 7.
Enter characters : T-V, t-v, 8.
Enter characters : W-Z, w-z, 9.
Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters : * + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow soft
key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Input Data
16 characters (SL1000)
48 characters (SL1100)
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
01 ~ 20
Message
SL1000/SL1100
Program
20
Default
Refer below
2-203