Selection Of Operation Mode - Toshiba TOSVERT VF-AS1 Instruction Manual

Frequency setting with operation panel and operation with terminal board
This setting is used to set the frequency using the operation panel and to perform operation control using the terminal
board.
Use the and
In sink logic mode: PWR-P24/PLC ON: Standby (ON (short-circuited) by default),
F-CC ON: Forward run, R-CC ON: Reverse run.
Frequency setting and operation with operation panel (=)
This setting is used to set the frequency and to perform operation control, using the operation panel.
Use the and
Use the and
RUN
5.5

Selection of operation mode

  : Command mode selection
  : Frequency setting mode selection 1
• Function
5
These parameters are to program which command to the inverter (from operation panel, terminal board, remote
input device or options) will be given priority in running/stopping the operation and in frequency setting (speed).
<Command mode selection>
[Parameter setting]
Title

[Programmed value]
:
:
:
:
:
* There are two types of function: the function that conforms to commands selected by , and the
function that conforms only to commands from the terminal board.
⇒ Refer to the table of input terminal function selection in Section 7.2.
* When priority is given to commands from a linked computer or terminal board, they have priority over the
setting of .
keys to set the frequency.
keys to set the frequency.
keys to perform operation control.
STOP
Function
:Terminal input enabled
:Operation panel input enabled (including LED/LCD option
Command mode input)
:2-wire RS485 communication input
selection
:4-wire RS485 communication input
:Communication option input
Terminal board operation
Operation panel operation
2-wire RS485 communication operation
4-wire RS485 communication operation
Communication option input enabled
Adjustment range
ON and OFF of an external signal Runs and stops operation.
RUN STOP
Press the and
stop a run. (including LED/LCD option input)
Run and stop commands are entered from the
2-wire RS485 communications device.
(Communication No.: FA00)
Run and stop commands are entered from the 4-wire
RS485 communications device.
(Communication No.: FA04)
Signals from an optional communication device are
used to start and stop operation.
⇒ For details, refer to Instruction Manual (E6581281,
E6581343, E6581288) specified in Section 6.42.
E-6
Default setting
keys on the operation panel to Run and
E6581528
