Displaying Static Port (And Trunk) Acl Assignments - HP 2530 Manual Supplement

Example 42 Listing the ACL assignments for a VLAN
The following output shows that all inbound IPv6 traffic and the inbound and outbound, routed
IPv4 traffic are all filtered on VLAN 20.
HP Switch(config)# show access-list vlan 20
Access Lists for VLAN 20
Ipv6 Inbound Access List: Accounting
Inbound Access List: None
Ipv6 Outbound Access List: None
Outbound Access List: 101
Type: Extended
Ipv6 VACL Access List: None
VACL Access List: None
Connection Rate Filter Access List: None

Displaying static port (and trunk) ACL assignments

This command lists the identification and types of current static port ACL assignments to individual
switch ports and trunks, as configured in the running-config file. (The switch allows one static port
ACL assignment per port.)
Syntax:
show access-list ports
Lists the current static port ACL assignments for ports and trunks in the running config
file.
NOTE: This information also appears in the show running output. If you execute the write
memory command after configuring an ACL, it also appears in the show config output.
"Listing the ACL assignments for ports and trunks" (page 99)
on various ports and trunks on the switch:
98 Updates for the HP Switch Software IPv6 Configuration Guide
An IPv6 ACL named "Accounting" is assigned to filter routed
1
IPv6 traffic entering the switch on VLAN 20.
There is no filtering of routed IPv4 traffic entering the switch on
2
VLAN 20.
There is no filtering of routed IPv6 traffic leaving the switch on
3
VLAN 20.
An extended ACL named "101" is assigned to filter routed IPv4
4
traffic exiting from the switch on VLAN 20.
There are no per-VLAN IPv6 ACLs assigned to VLAN 20.
5
There are no per-VLAN IPv6 ACLs assigned to VLAN 20.
6
There are no IPv4 Connection Rate Filter ACLs; see the chapter
7
"Virus Throttling (Connection-Rate Filtering)" in the HP Switch
Software Access Security Guide for your switch.
<all | <port-list>
1
2
3
4
5
6
shows IPv4 and IPv6 ACLs configured
7