Setting A Dscp Value For Outgoing Pim Messages; Displaying And Maintaining Pim - HP FlexFabric 5950 series Configuration Manual

Step
1. Enter system view.
2. Enable SNMP notifications
for PIM.

Setting a DSCP value for outgoing PIM messages

To control the transmission preference of outgoing PIM messages, set a DSCP value for outgoing
PIM messages.
To set a DSCP value for outgoing PIM messages:
Step
1. Enter system view.
2. Enter PIM view.
3. Set a DSCP value for
outgoing PIM messages.

Displaying and maintaining PIM

Execute display commands in any view and reset commands in user view.
Task
Display register-tunnel interface
information.
Display BSR information in the
PIM-SM domain.
Display information about the
routes used by PIM.
Display C-RP information in the
PIM-SM domain.
Display DF information in the
BIDIR-PIM domain.
Display PIM information on an
interface.
Display PIM neighbor information.
Display PIM routing entries.
Display RP information in the
Command
system-view
snmp-agent trap enable pim
[ candidate-bsr-win-election
| elected-bsr-lost-election
| neighbor-loss ] *
Command
system-view
pim
[ vpn-instance vpn-instance-name ]
dscp dscp-value
Command
display interface [ register-tunnel [ interface-number ] ] [ brief
[ description | down ] ]
display pim [ vpn-instance vpn-instance-name ] bsr-info
display pim
[ vpn-instance vpn-instance-name ] claimed-route [ source-address ]
display pim [ vpn-instance vpn-instance-name ] c-rp [ local ]
display pim [ vpn-instance vpn-instance-name ] df-info [ rp-address ]
display
pim [ vpn-instance vpn-instance-name ] interface [ interface-type
interface-number ] [ verbose ]
display
pim [ vpn-instance vpn-instance-name ] neighbor [ neighbor-address
| interface interface-type interface-number | verbose ] *
display pim [ vpn-instance vpn-instance-name ] routing-table
[ group-address [ mask { mask-length | mask } ] | source-address
[ mask { mask-length | mask } ] | flags flag-value | fsm
| incoming-interface interface-type interface-number
| mode mode-type | outgoing-interface { exclude | include
| match } interface-type interface-number | proxy ] *
display pim [ vpn-instance vpn-instance-name ] rp-info
150
Remarks
N/A
By default, SNMP notifications for
PIM are enabled.
Remarks
N/A
N/A
By default, the DSCP value for
outgoing PIM messages is 48.