Table of Contents
Advertisement
Figure 12 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Step
1.
Enter system view.
2.
Specify a source IPv4
address or source interface
for outgoing Telnet packets.
3.
Exit to user view.
4.
Use the device to log in to a
Telnet server.
Setting the DSCP value for IP to use for outgoing Telnet
packets
Step
1.
Enter system view.
2.
Set the DSCP value
for IP to use for
outgoing Telnet
packets.
Command
system-view
telnet client source { interface
interface-type interface-number |
ip ip-address }
quit
•
Log in to an IPv4 Telnet
server:
telnet remote-host
[ service-port ] [ source
{ interface interface-type
interface-number | ip
ip-address } ]
•
Log in to an IPv6 Telnet
server:
telnet ipv6 remote-host [ -i
interface-type
interface-number ]
[ port-number ]
Command
system-view
•
On a Telnet client running IPv4:
telnet client dscp dscp-value
•
On a Telnet client running IPv6:
telnet client ipv6 dscp
dscp-value
•
On a Telnet server running IPv4:
telnet server dscp dscp-value
•
On a Telnet server running IPv6:
telnet server ipv6 dscp
dscp-value
36
Remarks
N/A
Optional.
By default, no source IPv4
address or source interface is
specified. The IP address of the
outbound interface is used as the
source IPv4 address.
N/A
Use either command.
Remarks
N/A
The default is as follows:
•
16 for a Telnet client running
IPv4.
•
0 for a Telnet client running
IPv6.
•
48 for a Telnet server running
IPv4.
•
0 for a Telnet server running
IPv6.
Advertisement
Table of Contents
