Setting The Lock Code; Disabling The Lock Code; Changes To The Lock Code & Password - Pitney Bowes dm475m series Operator's Manual

Changes to the Lock Code and Password

Setting the Lock Code

The Lock Code prevents unauthorised access to your mailing system
after the machine has entered sleep mode or it is in a "soft" power-
down mode (by pressing the Lock/Power key on upper left corner of
the control panel).
1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select "Enable Lock Code".
5. At the prompt, type in a new numeric Lock Code (4 digits) and
select "OK".
6. Re-enter the new numeric Lock Code again to confirm and select
"OK".
7. At the "Lock Code enabled" message, select "OK".
8. Press Home to return to home menu.

Disabling the Lock Code

1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select "Disable Lock Code".
5. When prompted, enter the current numeric Lock Code and select
"OK".
6. Press Home to return to the home menu.
NOTE: The password 0000 cannot be used, as this
turns off the password feature.
Your DM300M/DM400M/DM475M mailing machine contains
postal funds and if you opt to use the 4-digit numeric Lock Code
to secure the funds, it is important that you do not allow your
Lock Code to be compromised if the machine is used in an open
area. If you believe your Lock Code has been compromised, it
should be changed immediately. Alternatively, you may wish to
consider locking the machine in a secure area.
SDC2036A
IMPORTANT INFORMATION
6 • System Options
6-7