Changing The Lock Code And Password - Pitney Bowes series DM200i series Operator's Manual

Changing the Lock Code and Password

Setting/Disabling the Lock Code
The Lock Code prevents unauthorised access to your mailing system
after the machine has entered sleep mode or it is in a "soft" power-
down mode (by pressing the Lock/Power key on upper right corner of
the control panel).
1. Press Options.
2. Press Page Down twice.
3. Select "LockCode/Passwords".
4. Select "Meter Lock Code". If there is an existing lock code, you
are prompted to key in the 4-digit code.
5. You then have a choice to either disable the lock code (if already
present) or change the lock code. "Change Lock Code" is also
used to create a code when one was not used before.
A. To disable the lock code:
Select "Disable Lock Code". At the confirmation message,
select "Continue".
B. To change or create a new lock code:
Select "Change Lock Code". At the prompt, type in a new
lock code (4 digits) and select "Continue". Re-enter the
new lock code again to confirm and select "Continue". At
the "Meter Lock Code has been enabled" message, select
"Continue".
6. Press Clear (back arrow key) twice to return to Options menu.
Your DM100i mailing machine contains postal funds and if
you opt to use the 4-digit Lock Code to secure the funds,
it is important that you do not allow your Lock Code to be
compromised if the machine is used in an open area. If you
believe your Lock Code has been compromised, it should be
changed immediately. Alternatively, you may wish to consider
locking the machine in a secure area.
SDC570F
IMPORTANT INFORMATION
6 • System Options
6-9