6 • System Options
Changing the Lock Code
You can change the Lock Code if it has been enabled.
1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select "Change Lock Code".
5. At the prompt, type in the current numeric Lock Code (4 digits)
and select "OK".
6. At the prompt, type in a new numeric Lock Code (4 digits) and
select "OK".
7. Re-enter the new lock code again to confirm and select "OK".
8. At the "Lock Code enabled" message, select "OK".
9. Press Home to return to home screen.
Setting/Disabling the Supervisor Password
The supervisor password prevents access to sensitive setup
procedures.
1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select either "Enable Password", "Disable Password" or "Change
Password" as required.
5. If there is an existing Supervisor Password, you are prompted to
key in the 4-digit numeric code, then select "OK".
6. If you are creating or changing the password, key in the new
4-digit numeric code that you require.
7. Select "OK".
8. Enter the new numeric code again to confirm, then press "OK".
The machine will confirm that the new password has been
enabled.
9. At the "Password Enabled" message, select "OK".
10. Press Home to return to the home screen.
Serial Port
This must be set to "Attached Scale". DO NOT select "External
Accounting".
6-8
SDC2036A