Changes To The Lock Code & Password; Setting The Lock Code; Disabling The Lock Code - Pitney Bowes DM300c series Operator's Manual

Changes to the Lock Code and Password

Setting the Lock Code

The Lock Code prevents unauthorised access to your mailing system
after the machine has entered sleep mode or it is in a "soft" power-
down mode (by pressing the Lock/Power key on upper right corner of
the control panel).
1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select "Enable Lock Code".
5. At the prompt, type in a new lock code (4 digits) and select "OK".
6. Re-enter the new lock code again to confirm and select "OK".
7. At the "Lock Code enabled" message, select "OK".
8. Press Home to return to home menu.

Disabling the Lock Code

1. Press Options.
2. Select "Setup".
3. Select "LockCode/Password".
4. Select "Disable Lock Code".
5. When prompted, enter the current Lock Code and select "OK".
6. Press Home to return to the home menu.
NOTE: The password 0000 cannot be used, as this
turns off the password feature.
Your DM300c/DM400c/DM475 mailing machine contains postal
funds and if you opt to use the 4-digit Lock Code to secure the
funds, it is important that you do not allow your Lock Code to
be compromised if the machine is used in an open area. If you
believe your Lock Code has been compromised, it should be
changed immediately. Alternatively, you may wish to consider
locking the machine in a secure area.
SDC755D
IMPORTANT INFORMATION
6 • System Options
6-9