How To Import Waypoints From External Device (Gp-80 Or Gp-90) - Furuno FEA-2807 Operator's Manual

13. Route Planning
13.5.8 How to import waypoints from external device
(GP-80 or GP-90)
You can import waypoints from external device such as a GPS navigator, like FURUNO GP-80 or GP-90, to the
current route. To import waypoints from an external device, do the following:
1. Click Route in the information area then click the Plan button to open the Plan Route dialog box. Click the
WPT tab to open the WPT page. Check Enable changes.
2. Click the Import button. The following dialog box appears.
WPT IMPORT
WPT
First WPT to copy
Number of WPTs
3. Enter where to import waypoints. To enter them after a WPT in a route, enter waypoint number in the "Copy
after WPT" box (if applicable). If you want to enter them before a WPT in the route, enter waypoint number in
the "Copy before WPT" box. Spin the scrollwheel to select desired number then push the scrollwheel.
4. Press the Copy from ext. device button.
WPT IMPORT
When the text "Import from ext. device: Waiting messages" appears, you can start importing WPTs (from a
GPS Navigator).
WPT IMPORT
You can monitor progress of the importing as shown above.
WPT IMPORT
When the importing is completed, the message "Transfer ready" message appears.
5. Click the Done button.
6. When finished, click X at top right corner of the dialog box to close the dialog box.
13-14
WPT
Copy after WPT
Copy before WPT
WPT
Copy after WPT
Copy before WPT
WPT
Copy after WPT
Copy before WPT
WPT
Copy after WPT
Copy before WPT