Danger Target Log; How To Show The Danger Target Log - Furuno FEA-2807 Operator's Manual

24.5

Danger Target Log

The Danger Target log stores information about targets that are received from a TT and/or targets that are received
from an AIS transponder (AIS targets).
If a tracked target or AIS target is within the set CPA and TCPA, information of all tracked targets (including non-
dangerous targets) are recorded into the Danger Target log. This data is as follows:
•
Date and time, index of target (number of tracked target on radar or IMO MMSI number from AIS
transponder).
•
CPA and TCPA of both AIS and tracked targets
•
Position (Lat, Lon), speed (Spd) and course (Crs) of both AIS and tracked targets.
•
Heading (Hdg) information of AIS target.
24.5.1

How to show the danger target log

To open the Danger Target log, do the following:
Use First 1000, Prev 1000, Next 1000 and Last xxx buttons to select desired time to be listed in log viewer.
Note: You can make a user chart from this log. See section 24.10 " How to Make a User Chart from a Log (past
track)".
1. Spin the scrollwheel to show Menu/Info/Chart Menu in the mouse functions area
then push the left mouse button.
2. Select Record from the menu then push the scrollwheel.
3. Select Danger Target Log from the menu then push the scrollwheel. The following
window appears.
4. Confirm that you want to open the log by clicking the OK button. Otherwise click
the Cancel button. The system will start viewing program of log.
You may print the entire log or a desired part. To change print font size, put the cursor
on the triangle and select desired font size. To print the log, click the Print Log button.
To print whole log, select Print All from the menu.
24. Recording Functions
24-7