Furuno FEA-2807 Operator's Manual page 219

Example of how to insert a nav aid
A light is only a light - it also requires a support that could be a pile or buoy, etc. Body and top mark of a buoy are
separated to enable a vast number of possible combinations.
1. Follow steps 1-3 on page 10-6 to display the Manual Update Planning dialog box.
2. Click the New button.
3. Select Point as Drawing Type; select Nav Aid as Category. Then use the cursor to select desired icon from the
master object.
4. Click the Set as Master button.
5. When you have set a master object, you can define nav aid slaves for it. Use the cursor to select desired icon (for
example, light) of a slave object.
6. Click the Set as Nav Aid Slave button. If you need more than one slave object continue from step 5.
7. When you are ready with master and its slave objects, click the Accept New Object button. The new object
w/slave (two lights) is shown in the list box.
8. Then, set the position of your master and slave objects. Click the Edit Properties button.
9. Click the Edit Position button.
10. Put the cursor on desired location on the ECDIS display and the push the left mouse button.
11. Click the Accept Manual Updates as Permanent button (11b in the illustration on the next page), or click the
Accept button (11a in the illustration on the next page).
12. Click the Accept button.
13. Click the Accept Manual Updates as Permanent button, and the object appears on the display at the position
selected.
8.
12.
3.
4.
10.
9.
11a.
13.
Set postion with cursor
and push left mouse
button. Press Accept
button.
11b.
Set position and then click
the Accept Manual
Updates as Permanent
button.
10. Manual Updates
5.
6.
7.
10-17