How To Activate Dialog Boxes On The Display - Furuno FEA-2807 Operator's Manual

3. ECDIS Display
3.3.4

How to activate dialog boxes on the display

The dialog boxes provide information to the use or a means to change equipment settings. The boxes are activated
by mouse-clicking over certain areas on the ECDIS display. Put the cursor on the appropriate area then click the
right or left mouse button to display the corresponding dialog box on the ECDIS display. See the figure below to
find the places and mouse button to click to get desired dialog boxes on the display. To close a dialog box, click the
X at the top right corner of the dialog box. Note that only one dialog box may be shown at a time.
Alerts
Alerts
WPT
PLAN ROUTE
Depending on your system configuration, the dialog box can overlap route monitoring information or other
information on the sidebar. In this case you can select where to open the dialog box, to the left of the sidebar or the
top of the sidebar, where it won't interfere with route monitoring information.
Function keys
Operation
Parameter backup
Digitizer
Backup and Restore
Installation parameters
Navigation parameters
Chart Alert parameters
Optimization parameters
Print Navigation parameters
Print Optimization parameters
Selftest
Standby
Presentation Library
Access Server and Diagnostic
Close
3-10
1. Open the Initial Settings menu.
2. Select Operation from the menu.
3. Select Dialog Position.
4. Select Left of sidebar to open dialog boxes left of the sidebar, or Top of sidebar to
open the boxes on the sidebar. (Select "Left of sidebar" for TCS without conning
display.)
(WT)
SET TIME
NAV
MARKS
ALERT
QUEUE
SENSORS
MON ROUTE