Furuno FEA-2807 Operator's Manual page 465

Alert number 456:
------------------------------------
'TIME TO WOP' HAS CHANGED SINCE 'WPT
APPROACH' ALERT WAS ACKNOWLEDGED,
POSSIBLY DUE TO A POSITION JUMP.
VERIFY POSITION AND SPEED SENSORS
IN 'SENSORS' PAGE
Alert number 458:
------------------------------------
FINAL WAYPOINT OF THE ROUTE IS
REACHED. LEAVE RC MODE BEFORE
ACKNOWLEDGED ALERT.
Alert number 460:
------------------------------------
THE RADIUS SENT TO AUTOPILOT IS
EXCEEDING THE MAXIMUM LIMIT FOR
TURNRATE. INCREASE THE RADIUS, OR
REDUCE SPEED.
Alert number 461:
------------------------------------
WAYPOINT IS BEING APPROACHED WITH
TOO HIGH SPEED FOR THE PLANNED
RADIUS, CAUSING MAX. TURNRATE TO BE
EXCEEDED. REDUCE THE SPEED OR
INCREASE RADIUS BY OVERDRIVING WITH
'MAN. SET COURSE'.
Alert number 464:
------------------------------------
NO ROUTE HAS BEEN SELECTED, AND
ROUTE STEERING CANNOT BE INITIATED.
SELECT A ROUTE AND NEXT WAYPOINT
THROUGH 'ROUTE MONITOR' PUSHBUTTON.
Alert number 465:
------------------------------------
ROUTE STEERING CANNOT START FROM
WAYPOINT 1. USE 'ROUTE MONITOR'
PUSHBUTTON TO SELECT "TO WPT" TO BE 2
OR HIGHER.
Alert number 468:
------------------------------------
ROUTE STEERING CAN ONLY BE INITIATED
WHEN SHIPS COURSE IS WITHIN THE
LIMIT FOR 'GoSEA' OR WITHIN THE
LIMIT FOR 'GoAW'. USE 'AUTO'
MODE TO STEER WITHIN THE LIMITS.
Alert number 470:
------------------------------------
RC STEERING MODE CAN BE USED
ONLY WHEN 'FILTER' IS ON AND THERE
ARE ENOUGH SPEED, HEADING AND
POSITION SENSORS. VERIFY AND SELECT
POSITION SENSORS IN 'SENSORS' PAGE
ROUTE: WPT APPROACH ERROR
ROUTE: LAST WPT APPROACH
PILOT: ROT WILL BE EXCEED
ROUTE: ROT WILL BE EXCEED
ROUTE: NO SELECTED ROUTE
ROUTE: ILLEGAL WPT
DISABLED: OUT OF COURSE
DISABLED: NEEDS FILTER ON
/3
/1 or /7
/6/13
/6/13
/4
/4
/3
/3
30. Alerts
30-35