Entering/Modifying Work Offsets; Entering/Modifying The Setting Data - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

A.2.2

Entering/modifying work offsets

Operating sequence
In case of any problems found when testing the tool offset result, you can proceed through the following steps to make tiny
adjustment of values:
A.3

Entering/modifying the setting data

Entering/modifying the setting data
Operating sequence
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015
1. Select the desired operating area.
2. Open the list of work offsets. The list contains the values of the basic offset of the pro-
grammed work offset and the active scaling factors, the mirror status display and the total of
all active work offsets.
3. Use the cursor keys to position the cursor bar in the input fields to be modified and enter the
values.
4. Confirm your entries. The changes to the work offsets are activated immediately.
1. Select the desired operating area.
2. Open the setting data window.
3. Open the window for setting the general data.
4. Position the cursor bar in the input fields to be modified and enter the values (see table
below for the parameter descriptions).
197