Automatic Machining - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

6

Automatic machining

Overview
The machine must have been set up for "AUTO" mode according to the specifications of the machine manufacturer. You can
perform such operations as program start, stop, control, block search, and real-time simulation, etc.
Softkey functions
→
①
Zooms in the actual value window
②
Performs the program test, dry run, conditional stop,
block skipping, and auxiliary function lock
③
Finds the desired block location
④
Corrects a wrong program block. Any changes will be
stored immediately.
⑤
Activates the simulation function
⑥
Sets the frequently used setting data
An extended horizontal softkey bar can be accessed via this key on the PPU. The following extended
horizontal softkey is provided:
36
Switch to "AUTO" mode by pressing these keys.
Assigns and activates the handwheel or contour handwheel. For more infor-
mation, refer to Section "Assigning the handwheel (Page 21)" and Appendix
"Activating the contour handwheel via the NC program (Page 205)".
⑦
Displays important G functions
⑧
Displays currently active auxiliary and M functions
⑨
Displays the axis feedrate in the selected coordinate
system
⑩
Displays the information of part machining time (part
timer) and part counter
⑪
Switches over the coordinate system in the actual value
window
Programming and Operating Manual (Turning)
6FC5398-5DP10-0BA2, 06/2015